Today I struggled with the front sway bar and it shouldn't have been that hard. There are two outside mounting brackets that are drilled off center and supposed to go in one way on top of the rear stabilizer bars. After renameing the sway bar "The Bitch", I figured if I swapped the mounting brackets from side to side I would gain the half inch I was short. Mother of Pearl, it fell right together. Some times your the windshield and sometimes your the bug.
Also applied the brake caliper brackets and temporarily put the calipers on.
Still need to put the rotors on with the bearings and seals but will do that after everything is painted. Also need to figure out where the brake line brackets will weld to the frame and not be in the way of any swinging parts.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment