Called Lynn about the rearend not seating and he came over. We decided the retainer rings that are pressed on after the bearings on the axles were too wide not allowing them to seat. He took the axles home and will cut a small portion off the rings. Should get them back this week.
Meanwhile, I bought a coil spring compressor and installed the springs in the front suspension along with the stablizing rods and the sway bar. All thats left there is the bearings and rotors. I will put the shocks in later.
I also made up a brake rod, which wasn't supplied, from the pedal to the brake booster using a 3/8 x 24 thread rod and a tube nut.
After repairing a hole blown in one of my sandblaster fittings I went back to blasting the cab. Got most of it done till I roll it back over.
Today I will go back and fill in some pin holes I blew in the floor boards when I was learning how to use my new welder.
Getting closer to priming the bottom of the cab.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment