Roll Pan

After a little research, decided to try to make a roll pan. The reason for this is to try to cover as much of the trailer hitch as possible. I also think I want the license plate to be just above the hitch in the middle of the roll pan.  Did a quick mock-up with a piece of peg board.  Thought  I might buy one off E-BAY, but went to a local metal shop and had them break a piece for me. I think the straight piece will cover the hitch better than a rolled one. The tail gate has a 1 1/4" rolled piece on the top and bottom. I bought a piece of 1" conduit and sliced one quarter out of it and will tack it on the corner to match the tail gate. Cold weather has set in so I left it here until it warms up.